REDSPEC wheel spacers 5 x 114.3 for MITSUBISHI

REDSPEC wheel spacers 5 x 114.3 for MITSUBISHI

REDSPEC wheel spacers are manufactured in high quality anodized aluminium, and are available for a wide range of applications.
Sold by pair.
Made in Italy.

Specifications:
PCD: 5 x 114.3.
Centre bore: 67.
Thread: M12 x 1.50.

Several models available:
- Without bolt: 16 or 20 mm thick
The bolts are not supplied with the wheel spacers.
These spacers may require longer studs or bolts depending on the length of the original and width of the spacer required.

- With stud bolt: 16 or 20 mm thick
The wheel spacers are supplied with the mounting hardware.
The supplied bolts are longer than the original one and adapted to the width of the wheel spacer.

- With double bolts: 20 or 30 mm thick, bolts with pre-installed stud bolts and nuts
Configuration used for important wheel spacers.
A set of bolts allows to fix the wheel spacer on the hub, while the other allows to fix the wheel on the wheel spacer.
Notes: If the thickness of the wheel spacers is less than the length of the original stud bolts, the correct contact between the wheel rims and the spacers cannot be guaranteed. Thus, the stud bolts should be shortened accordingly.
Wheel spacers with external centering.

For MITSUBISHI:
Evo V / VI / VII / VIII type CTO up to 2005.
Evo IX type CTO from 2005.
Evo X type CZO from 04/2008.
Lancer type CYO from 2008.
GT 3000 Z10 from 06/1992 to 08/1999.