REDSPEC Grooved drilled rear brake discs with bearings for RENAULT Clio IV RS 260x8 mm

REDSPEC Grooved drilled rear brake discs with bearings for RENAULT Clio IV RS 260x8 mm

Featuring a radical look, the drilled grooved discs have openings for easy heat dissipation and channels to clean the pad surface with each brake application.
All components for optimal braking!

Fits in place of your original discs (identical dimensions).
Please check carefully the compatibility of these discs with your vehicle.
These discs comply with ISO 9001, ISO/TS 16949 and TÜV standards.
Sold in pairs.

For optimum performance, please make sure to follow the running-in phase described below:
1. 1. Plug the cooler inlet to 3/4
2. 2. Use ground (hard) inserts.
3. Gradually heat the discs for the first 15 kilometers.
4. 4. Use the vehicle normally without being violent on the brakes.
5. 5. Finish with 5 or 6 hard brake applications.
6. If thermal paints are used (part number CP26491) only the green paint (430°C) should have whitened and the orange paint should barely begin (560°C).

In order to operate with the best efficiency and last as long as possible, the disc temperatures must be correct and balanced.
In general, all discs in a vehicle should operate at the same temperature.
The maximum disc temperature should be matched with the quality of the pads used.
The disc faces should not exceed the maximum temperatures recommended for each type of insert.