REDSPEC drilled and grooved brake discs for R4 or R18 228x10 mm front or rear

REDSPEC drilled and grooved brake discs for R4 or R18 228x10 mm front or rear
With their radical styling, these drilled and grooved brakes have apertures that facilitate heat dissipation and channels that clean the brake pad surface every time you brake.
All the components required for optimal braking!
Can be fitted as a direct replacement for your standard discs (identical dimensions).
Please check the compatibility of these discs with your vehicle.
These discs comply with standards ISO 9001, ISO/TS 16949 and TÜV.
Sold as a pair.
Specifications:
Front disc or rear disc
Diameter: 228 mm
Thickness: 10 mm
- Number of holes: 6
Suitable for:
RENAULT R18 GTL
RENAULT R18 Break GTL
RENAULT R4 1.1
For optimal performance, please comply with the running-in phase described below:
1. Block off 75% of the cooler intake 2. Use brake pads that have been run in (hard)
3. Warm the discs up gradually over the first 15 kilometres.
4. Drive normally, without braking sharply.
5. Brake sharply 5 or 6 times to finish off.
6. If heat protective paint is used (ref.CP26491), only the green paint (430°C) should have turned white, with the orange hardly touched (560°C).
To ensure optimal performance and durability, disc temperature must be correct and balanced.
Generally speaking, a vehicle's discs should all work at identical temperatures.
The maximum temperature of the disc must be compliant with the quality of the brake pads used.
The disc sides must not exceed the recommended maximum temperatures for each type of brake pad.