PAGID Brake Pads Shape n°2557 Compound RST2E

PAGID Brake Pads Shape n°2557 Compound RST2E

RST2E is a semi metallic resin bonded material containing steel fibers. Cold friction and initial bite makes this material most appropriate for Rally and NASCAR applications.

Rally tarmac, GT cars and Touring cars circuit racing and NASCAR. Also used as rear pad in combination with RST1 front. Recommended for GT and Touring Car racing on tracks where higher temperatures are an issue.

All PAGID products are made in Germany!

Length x Width : 163 mm x 68,6 mm
Thickness : 29 mm

Car applications, dimensions and pad schemes are supplied as a guide. Please check your assembly before ordering

Front brake pads for :

BMW Z4 GT3 race car (years 2013 à 2015)
McLaren MP4-12C GT3 race car (years 2013 à 2015) - NB : Akebono caliper

For brake calipers :

Alcon - DP88, TA6+, CAR95 [4495] - pad thickness : 29.0 mm
AP Racing - CP6080 D54 - pad thickness : 29.0 mm
AP Racing - CP6210 D54 - pad thickness : 29.0 mm
AP Racing - CP6269 - pad thickness : 29.0 mm

On vehicle bedding-in procedure:

Step 1 - Breaking-in
Creating a perfect contact-pattern between rotor and brake pad surface.
10 stops with mid pressure and low temperature from 150 km/h (90 MPH) to approximately 80 km/h (50 MPH).

Step 2 - Heating-up
Warm up in order to initiate some core heat in the whole brake system.
A sequence of 5 stops with medium to high pressure from 180 km/h (112 MPH) to approximately 60 km/h (40 MPH) with maximum acceleration between the stops.

Step 3 - Recovery Stops
3 to 5 stops with mid pressure from 150 km/h (90 MPH) to approximately 80 km/h (50 MPH).