Alfano LSU 4.9 Wideband Lambda Probe Pack for Alfano 7: Optimize your Fuel

LSU 4.9 Wideband Lambda Probe Pack for Alfano 7: Optimize your Fuel

Control the efficiency of your motor with the Bosch LSU 4.9 Wideband Lambda Sensor Kit. This precision telemetry tool allows you to measure the Air-to-Fuel Ratio (AFR) in real time over the entire rev range (low and high revs). It is the essential accessory to adjust your carburation or injection and obtain maximum engine performance.

Why install an LSU 4.9 Lambda sensor on your Alfano 7?
Unlike conventional sensors, Broadband technology offers an ultra-accurate and instantaneous reading of exhaust gases.

- Instant Engine Tuning: Immediately identify if your engine is too "rich" or too "poor".
- Consistent Performance: Optimize the air/fuel mixture to gain torque and power at all RPMs.
- Engine protection: Avoid the risk of engine breakage due to a mixture that is too lean during phases of intensive acceleration.

Compatibility and Connection

- This system is exclusively designed to integrate with the Alfano 7 ecosystem.
- Direct connection: Plugs into the black port (BUS) of the Alfano 7.
- Box12 expansion: Also compatible via the orange port of your Box12 module.

Warning: Electrical prerequisites: This system requires a 12V direct current power supply (battery) to operate and heat the sensor properly.

Composition of the Pack (Official References):
The kit is delivered complete and ready to install:

- A2503: Bosch LSU 4.9 Lambda sensor (world reference for accuracy).
- A2504: Dedicated electronic controller (signal management box).
- A2505: Fixing kit including a stainless steel threaded nut to weld on your exhaust pipe and a plug (bolt) to close the hole if necessary.